Effects of Various Warm-Up Devices and Rest Period Lengths on Batting Velocity and Acceleration of Intercollegiate Baseball Players

• Autores: Jacob M. Wilson, Abraham L. Miller, David J. Szymanski, Nevine M. Duncan, Jody C. Andersen, Zane G. Alcantara
• Localización: Journal of strength and conditioning research: the research journal of the NSCA, ISSN 1064-8011, Vol. 26, Nº. 9, 2012, págs. 2317-2323
• Idioma: inglés
• Texto completo no disponible (Saber más ...)
• Resumen

  • It is common among competitive baseball players to swing bats while in the batter's box in an attempt to improve their batting performance. Players use bats of different weights during this time, and only a few studies have evaluated the optimal bat weight to increase performance. Previous studies have not investigated the optimal rest period after a warm-up with bats of varying weights. Therefore, we tested the peak bat velocity of 16 National Collegiate Athletic Association Division II intercollegiate baseball players at 1, 2, 4, and 8 minutes, after warming up with bats of 5 different weights. Measured variables were peak bat velocity at peak acceleration (PVPA), peak bat velocity of the swing (PV), peak bat acceleration (PA), and time to reach peak acceleration (TPA) using a chronograph, which measured the batting velocity in real time every 10 milliseconds throughout the swing. A repeated measure analysis of variance was run to assess group, time, and group by time interactions. If any main effects were found, a Tukey post hoc was employed to locate differences. There were significant (p <= 0.05) time effects for PVPA, PV, and PA but not for TPA. The PVPA, PV, and PA all increased over time, peaking from 4 to 8 minutes. There were no significant differences in any of the variables among the 5 bat weights used in the warm-up (p > 0.05). However, there were significant differences in PVPA, PV, and PA after 2, 4, and 8 minutes of rest compared with the preexperimental warm-up and 1-minute post�warm-up. From a practical standpoint, batters should warm up early and quickly in the batter's box to maximize the amount of recovery time before they swing at the plate. In addition, batters may want to take their time getting ready at the plate or take some pitches while at-bat in an attempt to maximize performance. Alternatively, the data imply that pitchers should throw their fastest pitch near the beginning of the at-bat to correspond with the potentially slower bat speeds of the batter.