The aim of the present study was to analyze the main determinants of an upper-body repeated power ability (RPA) test and to examine its reliability and usefulness. Forty-five highly trained, male, young basketball players performed the RPA test (5 sets of 5 repetitions with 30 seconds of passive recovery within sets) on 2 sessions separated by 5�7 days. Power output was registered using a linear encoder attached to the barbell. Results showed no significant differences (p > 0.05) between each set in both sessions and trivial (<0.2) effect sizes in all the analyzed variables. For every set, intraclass correlation coefficient was very high (0.96�0.98) and coefficient of variation was low (3.3%�4.3%). Because the typical error of measurement values were lower or similar than the smallest worthwhile change (SWC0.2 = 0.2 × between-subject SD), the usefulness of most variables was rated as �good� or �OK� considering that small changes would be detected by this test. The percentage of power decrement could only be used to detect large effects (>1.2 × between-subject SD). An almost perfect correlation (r = 0.99; 90% confidence interval, 0.98�0.99) was found between the average power in set 1 (APbest) and the average power over 5 sets (APmean). In conclusion, the main determinant of RPA test is APbest, and because of the high reliability scores obtained, this protocol may be used to assess upper-body RPA in relatively experienced young athletes.
© 2001-2024 Fundación Dialnet · Todos los derechos reservados