Shear bond strengths of composite resin and giomer to mineral trioxide aggregate at different time intervals

• Amir-Ahmad Ajami ^[1] ; Mahmoud Bahari ^[2] ; Arezoo Hassanpour-Kashani ^[3] ; Mehdi Abed-Kahnamoui ^[1] ; Ayda Savadi-Oskoee ^[1] ; Farhad Azadi-Oskoee ^[1]
  1. [1] Tabriz University of Medical Sciences

     Tabriz University of Medical Sciences

     Irán

     
  2. [2] Assistant Professor, Department of Operative Dentistry, Faculty of Dentistry, Tabriz University of Medical Sciences, Tabriz, Iran; Dental and Periodontal Research Center, Faculty of Dentistry, Tabriz University of Medical Sciences, Tabriz, Iran
  3. [3] Endodontist, Private Practice, Tabriz, Iran

  Mostrar afiliaciones +
• Localización: Journal of Clinical and Experimental Dentistry, ISSN-e 1989-5488, Vol. 9, Nº. 7 (July ), 2017, págs. 906-911
• Idioma: inglés
• Enlaces
  • Texto completo
• Resumen

  • The efficacy of the bond between the restorative materials and the pulp capping materials has an important role in the success of vital pulp therapy. Therefore, the aim of this study was to evaluate the shear bond strength of composite resin and giomer to MTA at different time intervals after mixing of MTA.

    Ninety cylindrical MTA samples were prepared and assigned to two groups (n=45) based on the restorative materials used (composite resin or giomer). Each group was subdivided into 3 subgroups (n=15) based on the evaluation intervals (immediately, 2.45 hours and 3 days after mixing MTA). After the bonding procedures, the shear bond strengths of the samples were measured in MPa at a strain rate of 0.5 mm/min. Data were analyzed with repeated-measures ANOVA, post hoc tests and t-test (P<0.05).

    Bond strength of composite resin was minimum at baseline but it increased significantly 2.45 hours after mixing MTA (P=0.002), with no significant changes in bond strength up to three days (P=0.08). Bond strength of giomer did not exhibit any significant changes from baseline to 2.45 hours after mixing MTA (P=078); however, at 3 days it reached a minimum (P=0.000). In addition, the means of bond strength of composite resin 2.45 hours and 3 days after mixing were significantly higher than those of giomer (P=0.001 and P=0.000, respectively).

    Bond strengths of composite resin 2.45 hours and also 3 days after mixing were significantly higher than those of giomer. In addition, the shear bond strength of giomer decreased over time; however, the shear bond strength of composite resin increased.