Eusebio Dionicio Padilla, Manuel Caballero Ríos, Victor Vega Guillen, Oswaldo Gonzales Reynoso, Luis Orihuela Salazar
El presente estudio ha determinado que los materiales de latón al bismuto: 1.11%, 1.46% y 2.48%, respectivamente, presenten características como sigue: El material latón al bismuto trefilado, barra redonda uniforme de 19 mm, cuya microestructura está formado por cristales α + β presenta inclusiones de bismuto en los límites de grano y en el grano. La deformación del grano es más pequeño en la superficie, siendo mayor el grano a medida que se llegue al centro. Las propiedades mecánicas del material trefilado de 19 mm. I y II son mayores al establecido por la norma ASTM B 16/B 16M., siendo la dureza HRB mayor a lo establecido por dicha norma. Asimismo el material es forjable al obtenerse piezas de volante para las válvulas de gas. El índice de maquinabilidad de los materiales trefilados de latón que presenta bismuto entre 1.0 y 2.5 % deben estar entre 85 y 90.
The current study has determined that the materials from brass to bismuth, 1.11%, 1.46% and 2.48% respectively, have the following characteristics: the brass to bismuth material drawing, uniform round bar of 19 mm which microstructure is formed by α + β, shows inclusions of bismuth in the grain limits and in the same grain. The grain deformation is smaller on the surface, and it becomes bigger as it reaches the center. The mechanical properties of the 19 mm drawing material, I and II are bigger than the established by the ASTM B 16/B 16M, being the HRB hardness higher than the established by the norm. Also the material is wrought to obtain pieces for gas valves. The machinability index of the brass’s drawing materials that contains bismuth between 1.0 and 2.5% should be in a range from 85 and 90
© 2001-2024 Fundación Dialnet · Todos los derechos reservados