Effect of Posterior Residual Ridge Resorption and Relining for Mandibular Implant Overdentures on Bending Strain Around Implants

• Autores: Nguyen Quan Pham, Tomoya Gonda, Toshihito Takahashi, Yoshinobu Maeda, Kazunori Ikebe
• Localización: The International Journal of Oral & Maxillofacial Implants, ISSN-e 0882-2786, Vol. 37, Nº. 1, 2022, págs. 49-56
• Idioma: inglés
• Enlaces
  • Texto completo
• Resumen

  • Purpose: To examine the influence of posterior residual ridge resorption (PRRR) and relining on bending strain around implants under an overdenture.

    Materials and methods: Maxillary and mandibular edentulous models were made and covered with white silicone. Four strain gauges were placed on four sides of each implant. Two tissue-level implants were placed bilaterally in the part between the lateral incisors and canines of the mandible. A maxillary conventional denture and a mandibular overdenture were fabricated to fit the models. Three levels of bone resorption around the implant were created: 0, 0.8, and 1.5 mm. The surface of the residual ridge was uniformly removed from the area near the distal side of the implant to the retromolar section, and three levels of PRRR were created (0, 1, and 1.5 mm). After the measurement, the experimental denture of the PRRR of 1 mm and 1.5 mm were relined. Locator attachments were used. A 98-N occlusal force was applied, and bending strains around the implant were measured. The Kruskal-Wallis test and Bonferroni correction were employed to analyze the data.

    Results: Without relining, at each bone resorption level around the implant, the bending strain was smallest with PRRR of 0 mm and largest with PRRR of 1.5 mm. The bending strain after relining was smaller than the bending strain with ridge resorption. Bending strains after relining were smaller than bending strains with no ridge resorption, but there was no significant difference in bending strain between these three groups.

    Conclusion: As PRRR increased, the bending strain increased without relining. As bone resorption around the implant progressed, PRRR enhanced the increase in the peri-implant bending strain. Bending strain was reduced when relining was performed.